ASTM C773 PDF

Purchase your copy of ASTM C – 88() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Designation: C − 88 (Reapproved ) Standard Test Method for For referenced ASTM standards, visit the ASTM website, , or. Find the most up-to-date version of ASTM C at Engineering

Author: Mazilkree Zoloshicage
Country: Cape Verde
Language: English (Spanish)
Genre: Literature
Published (Last): 4 December 2008
Pages: 50
PDF File Size: 6.87 Mb
ePub File Size: 12.11 Mb
ISBN: 189-7-82494-976-3
Downloads: 86612
Price: Free* [*Free Regsitration Required]
Uploader: Zuluzragore

C 5 compressive strength of the specimen, psi or MPa; P 5 total load on the specimen at failure, lbf or N; and A 5 calculated area of the bearing surface of the specimen, in.

ASTM International – Laboratory Directory – University of Dayton Research Institute

Current edition approved Sept. C — 88 Reapproved Standard Test Method for Compressive Crushing Strength of Fired Whiteware Materials1 This standard is issued under the fixed designation C ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

  ASTM C151 PDF

They may be formed and matured for the purpose of compression testing, or they may be cut from matured whitew- are by sawing or coredrilling. Place an appropriate guard around the specimen to contain flying fragments at failure; eye protection should be used by the operator. NOTE 1—It is desirable to include details of the origin of the specimen and subsequent treatment. Precision and Bias 8. The ends of all specimens shall be ground or lapped to yield plane and parallel asmt. It is the axtm of the user of this standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use.

Enviado por Thamyres flag Denunciar. Suitable materials for cushion pads, selected in accordance with the compressive strength range of the material being tested, are shown in the following table: Discard 7c73 pieces xstm cracks or flaws visible to the unaided eye.

Originally published as C — 74 to replace C and C A number in parentheses indicates the year of last reapproval. Ideally, ceramics should be stressed this way in use. If the contact block is cracked during testing, it shall be replaced.

  INFIX POSTFIX PREFIX CONVERSION PDF

ASTM C 773 – 88

A superscript epsilon e indicates an editorial change since the last revision or reapproval. Significance and Use 3. Last previous edition C — 88 One operator in each laboratory tested ten specimens of each material.

These faces shall be perpendicular.

This test is a measure of the potential load-bearing usefulness of a ceramic. The spherical surfaces shall be well lubricated, and the center of curvature shall lie on the lower face of the platen.

Single-operator component Between-laboratory component 1. New cushion pads shall be used for each specimen. The compo- nents of variance for compressive strength results expressed as coefficients of variation were c7773 as follows:

Author: admin